Franklin Furnace Solar Power Information & Peak Sun Hours

Solar Green Energy Summary for Franklin Furnace, Ohio

Lattitude: 38.6115

Sunlight

Fixed Tilt Sunlight Hours: 4.4 hours per day

1-Axis Tilt Sunlight Hours: 5.3 hours per day

2-Axis Tilt Sunlight Hours: 5.6 hours per day

If you put your solar powered math calculator in your backpack it will turn off from the lack of sunlight needed to power the device. As you slowly open your backpack and begin to let sunlight in, the calculator will eventually turn on when the amount of sunlight is enough to power the calculator. Similarly, peak sun hours refer to the hours of they day where the sunlight is strong enough to power a solar panel. This is different from total sunlight hours, which is simply the amount of hours in a day when there is any sunlight.

The latitude at the equator of the earth is zero degrees. This is where sunlight strikes the earth most directly. Due to the earth's curved shape, sunlight hits at a various angles depending on location. As latitude increases, the further you are located from the equator and more variance you see in sunlight hours. The latitude of Franklin Furnace is 38.6.

A tracking mount will increase the average peak sun hours for a solar power system. Think about a panel that is tracking the sun in the sky vs a panel that is fixed and not moving: you will see a higher efficiency ratio of productions. A 1-axis mount will track the sun from East to West from sunrise to sunset and move on a single axis of rotation. A 2-axis mount will track the Sun from East to West the same as a 1-axis mount would, but it will also track the angle of the sun in the sky as it slowly varies season to season. A 2-axis mount is more necessary in high latitude regions where the angle of the sun in the sky changes dramatically between each equinox.

Although weather predicting technology has greatly evolved over time, it is still a rather unpredictable factor that will affect the amount of peak sun hours your solar power system will receive. Cloudy days for example will usually have lower peak sun hours that a clear sunny day. And areas that usually have more average sunny days per year will probably have higher peak sun hours that areas that are often overcast or stormy.

We can use previous years of data to estimate the amount of peak sun hours in Franklin Furnace. A fixed tilt mount for example will receive 4.4 average hours per day. For more efficiency for your system in Franklin Furnace you could use a 1-axis tracking mount and increase your daily peak sun average to 5.3 hours, or even further with a 2-axis panel to get an average of 5.6 hours.


Solar Businesses in Franklin Furnace, Ohio




Leave a Reply

Your email address will not be published.